PUSHBACK DEFINITION

 

There are actually two types of pushback vehicles: the regular Pushback, and the SmallPushback. The former is used to push back large aircraft, generally airliners, while the latter is aimed for smaller aircraft, usually jets as well as small GA aircrafts. Both behave the same way in the end, from a behavior and general configuration perspective.

A Pushback Pushing An A320Neo

A Small Pushback Pushing A Cessna 172 SkyHawk

 

Model Notes

Contrary to all other types of Ground Vehicles, the Pushback (and SmallPushback) must have its origin position located in the place where the wheel of the aircraft will attach, and not the center of the vehicle. And by "origin position", we mean the point of coordinates (0,0,0) in the scene when exporting the glTF file of the vehicle.

 

Moreover, the "front" of the Pushback must be the part closest to the aircraft when attached, and the "back" of the Pushback being the side farthest away from the attach point. In other words, the Pushback will move forward when pushing an aircraft, and backwards when detaching from the aircraft.

 

 

Sim.cfg

Except for the origin position, and the possible confusion of "which side is the front ?", Pushback vehicles have the same configuration as regular Ground Vehicle sim.cfg.

 

 

Model Behavior Helper

And additional model behavior helper is available for Pushbacks with an include of "Asobo_Misc.xml": ASOBO_Pushback_Attach. This template takes two parameters, ANIM_NAME and PERCENT_PER_SECOND, and plays the corresponding animation when the pushback attach itself to the aircraft, and plays this animation backwards when the pushback detach itself. PERCENT_PER_SECOND determines the speed of the animation. We recommend using a short animation (if any), as the Pushback will not wait for the end of this animation to start moving after attaching or detaching itself.