The Add Node

This Node can be used to get the sine of an input value. You can specify the value to use, or supply a Node Inputs, and the node will output the sine value. When specifying the value, you can input it directly to the node input box, or you can input it through the Inspector window:
The Inspector Window Inputs For The Add Node


From the Inspector window you can also select the Input Unit, which is either Radians or Degrees.



Node Inputs

This node accepts the following the inputs:


  • X
    The value to get the sine of. If using a node input, the input must be a single value as vectors are not supported.



Node Output

The node will output a scalar (float) value.